Components PRO

ل.س 0.0

The Components Pro formula was created by qualified specialists based on many years of experience.


The Components Pro formula was created by qualified specialists based on many years of experience. Unlike traditional methods of reef tanks supplementation, the Aquaforest method is highly efficient, it has also been modified and enriched with all the microelements necessary for the proper functioning of the aquarium. Regularly dosed fluids provide adequate levels of carbonate hardness, magnesium and calcium (KH 6.5-8.5, Ca 380-460 ppm, Mg 1180-1460 ppm). Moreover, this specialist formula allows maintaining the right amounts of microelements, which doses are difficult to determine in home conditions, require constant monitoring and regular supplementation.
Components PRO Kit Contains
5000 mL Component PRO 1 (Ca, Sr, Fe, Mn, Cu, Zn, Ni, Cr, Co, Mo)
5000 mL Component PRO 2 (Kh- HCO3, F, I)
5000 mL Component PRO 3 (Mg, S, K, B, Sr, Li)
Dosing Instructions
Dosing will vary per your aquariums demand for trace elements. All the fluids should be dosed equally based on Ca, KH and Mg consumption. Regularly test your water and establish the optimal dose basing on analysis results. With average SPS corals stock, the recommended Components Pro dose is 12 ml per 100 liters of water daily. When water parameters aren’t in the recommended range use one of the Aquaforest Lab additives (Ca Plus, Mg Plus, KH Plus) until reaching the desired levels.
Component 1 Pro contains: Ca, Sr, Fe, Mn, Cu, Zn, Ni, Cr, Co, Mo (25 ml / 100 l raises Ca by 9 ppm). Component 2 Pro contains: HCO3, F, I (25 ml / 100 l raises KH by 1.3 dKH – Alk 0.46 meq / l). Component 3 Pro contains: Mineral salts, Mg, S, K, B, Sr, Li (25 ml / 100 l increases Mg by 0.76 ppm). Due to the high concentration of the product, we recommend regular maintenance of the dosing lines. Keep away from children. The product can be used only in the aquarium. Not suitable for consumption. Safety data sheet available on request.
With an average coral stocking: 12 ml daily/100 liters (27 US gal) of water
Note: Dosing components too quickly together may cause precipitation. We recommend 1 hour between each components addition, helping prevent elements from falling out of solution.


There are no reviews yet.

Be the first to review “Components PRO”

Your email address will not be published.

Translate »